1 °) Demonstrate the pump:- Remove the protection of the tank, to access it and the white plastic support with tabs under which the pump is located. And slowly shoot it to separate it from white support. 2 °) Install the pump:- Place the new pump on the white support by putting pressure as much as possible so that it is well fixed and that it does not fall by itself .- Connect the electric part of The pump with white support and place it again on the tank by fixing it using the tabs.- Finally, cover the tank with its protection. 4°) CONNECT THE DIAGNOSTIC DEVICE: Finally, activate the “reservoir replacement” process for correct priming of the pump. At one point, the computer will ask you to wait about 15 minutes, which is necessary to prime the pump intermittently. Then the computer will i.
